cluster-membership-show

To display a cluster membership for high availability (HA) in a fabric, use the cluster-membership-show command.


 

Informational Note:  You may configure multiple clusters of switches within a single fabric. However, a switch can participate in only one cluster configuration. For example, switch-1 and switch-2 can participate in cluster-1, and switch-3 and switch-4 can participate in cluster-2, but switch-1 and switch-2 cannot participate in cluster-2 or any other cluster.

Syntax   cluster-membership-show

name name-string

Specify the name of the cluster membership.

id

Specifies the ID assigned to the cluster.

state offline|online|unavailable|coming-online|slave-ready|
going-offline

Specifies the state of the cluster.

cluster-node-1

fabric-node name

Specify the name of the first fabric node in the cluster.

cluster-node-2

fabric-node name

Specify the name of the second fabric node in the cluster.

tid tid-number

Specifies the transaction ID assigned to the cluster.

mode none|master|slave

Specifies the cluster mode.

ports port-list 

Specifies the list of ports.

remote-ports port-list

Specifies the list of remove ports.

Defaults   None

Access   CLI

History   

Version 2.5.0

Command introduced.

Version 3.0.0

The parameter validate|no-validate deprecated.

Usage   A cluster allows two switches to cooperate in high-availability (HA) deployments. The nodes that form the cluster must be members of the same fabric. Clusters are typically used in conjunction with a virtual link aggregation group (VLAG) that allows links physically connected to two separate switches appear as a single trunk to a third device. The third device can be a switch, server, or any Ethernet device.

Examples  To display a cluster membership, use the following command:

CLI network-admin@switch > cluster-membership-show

See Also   

cluster-delete

cluster-show