igmp-static-group-delete

This command deletes information about IGMP snooping on the network..


 

Informational Note:  IGMPv1 is not supported by Pluribus Networks. If you are using IGMPv1, you must disable IGMP snooping on the Pluribus Networks switch.

Syntax   igmp-static-group-delete [group-ip ip-address] [vlan vlan-id]

group-ip ip-address

Specify the group IP address for IGMP.

vnet vnet name

Specify the VNET to delete.

l2-net l2-net name

Specify the group Layer 2 network.

vlan vlan-id

Specify the VLAN identifier.

Defaults   None

Access   CLI

History   

Version 1.2

Command introduced.

Version 2.1

The parameters, ports, is deprecated.

Version 3.0.0

The parameters, vnet and l2-net, added.

Usage   IGMP groups are used to determine the reception state for a specific multicast address. This allows the switch to determine if any switches need messages sent from a multicast group. Use this command to remove an IGMP static group.

Examples  To delete a static group for 239.4.9.3 on VLAN 202 and ports 55-57, use the following command:

CLI network-admin@switch > igmp-static-group-delete group-ip 239.4.9.3 vlan 202 ports 55-57

See Also   

igmp-show

igmp-snooping-modify

igmp-snooping-show

igmp-static-group-create

igmp-static-group-show

igmp-static-source-delete

igmp-static-source-show