igmp-static-source-delete

This command deletes a static IGMP source on the netework.


 

Informational Note:  IGMPv1 is not supported in ONVL. If you are using IGMPv1, you must disable IGMP snooping on the Pluribus Networks switch.

 

Syntax   igmp-static-source-delete [group-ip ip-address] [source-ip ip-address] [vlan vlan-id]

group-ip ip-address

Specifies the group IP address for IGMP.

source-ip ip-address

Specifies the source IP address.

l2-net l2-net name

Specify the group Layer 2 network.

vlan vlan-id

Specifies the VLAN identifier.

Defaults   None

Access   CLI

History   

Version 1.2

Command introduced.

Version 2.4.1

The parameter, vnet, added.

Version 3.0.0

The parameter l2-net added.

Usage   IGMP groups are used to determine the reception state for a specific multicast address. This allows the switch to determine if any switches need messages sent from a multicast group. Use this command to remove an IP address as the static source.

Examples  To remove the static source 12.0.0.1 as the static source, use the following command:

CLI network-admin@switch > igmp-static-source-remove source-ip 12.0.0.1 group-ip vlan 202 ports 55-57

See Also   

igmp-show

igmp-snooping-modify

igmp-snooping-show

igmp-static-group-create

igmp-static-group-delete

igmp-static-source-delete

igmp-static-source-show