ip-pool-show

This command displays information about an IP address pool with a specific IP address range.

Syntax   ip-pool-show name ip-pool-name vnet vnet-name scope local|fabric start-ip ip-address end-ip ip-address network ip-address netmask netmask [vlan vlan-id]

name ip-pool-name

Specifies the name of the IP pool.

vnet vnet-name

Specifies the VNET for the IP pool.

scope local|fabric

Specifies the scope of the VNET.

start-ip ip-address

Specifies the first IP address in the pool. This address is included in the pool.

end-ip ip-address

Specifies the end IP address of the pool and is included in the pool.

network ip-address

Specify an IP address group such as 192.168.11.0.

netmask netmask

Specifies the subnet for the IP address pool.

l2-net l2-net-name

Specify the name of the Layer 2 network.

vlan vlan-id

Specifies the VLAN identifier for an IP address pool that applies to a specific Layer 2 network segment.

Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.

sort-asc

Display output in ascending order.

sort-desc

Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.

show-headers|
no-show-headers

Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.

count-output

Display the number of entries in the output. This is useful with vRouter show commands.

unscaled

Display full values in the output instead of scaled approximate values.

raw-int-values

Display integer values instead of mapped values

sum-by

Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.

Defaults   None

Access   CLI

History   

Version 1.2

Command introduced.

Version 2.2

The parameter, vnet, deprecated.

Version 3.0.0

The parameter, l2-net, added.

Usage   IP address pools help automate the management of IP addresses for hosts and virtual machines, including the management IP addresses of the switches in a fabric.

Examples  To display information about a fabric-wide IP address pool named vPool, use the following command:

CLI network-admin@switch > ip-pool-show name vPool

Name   Owner   Scope   Range Start    Range End      Nemask   Gateway   DNS

vPool  None    local   192.168.240.1  192.168.240.254 24      10.9.40.1  0

See Also   

ip-pool-create

ip-pool-delete

ip-pool-modify