lacp-modify

This command is used to modify Link Aggregation Control Protocol (LACP) parameters on the switch.

Syntax   lacp-modify [enable|disable] system-priority priority

Specify one or more of the following options:

enable|disable

Specify to enable or disable LACP on the switch.

system-priority priority

Specifies the priority for the configuration. The default value is 32768 with a range of 1 to 65535.

Defaults   The default system-priority is 32768.

Access   CLI

History   Command introduced in Version 1.2.6

Usage   Use this command to enable or disable LACP and set the priority.

Examples  To enable LACP with a priority of 3567, use the following command:

CLI network-admin@switch > lacp-modify enable system-priority 3576

See Also