running-config-show

This command displays information about the current configuration on the switch.

Syntax   running-config-show

Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.

sort-asc

Display output in ascending order.

sort-desc

Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.

show-headers|
no-show-headers

Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.

count-output

Display the number of entries in the output. This is useful with vRouter show commands.

unscaled

Display full values in the output instead of scaled approximate values.

raw-int-values

Display integer values instead of mapped values

sum-by

Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.

Defaults   None

Access   CLI

History   

Version 1.2

Command introduced.

Version 2.5.3

VNET administrator-related information displays when a VNET administrator runs this command.

Usage   Displays information about the current configuration on the switch.

Examples  To display the configuration, use the following command:

CLI network-admin@switch > running-config-show

The output is lengthy and includes port information, IP addresses, VNETs, and so on.

To view VNET administrator information:

1. Enable running-config for the VNET admin role, (vnet1-admin):

CLI network-admin@switch > role-modify name vnet1-admin running-config

2. Log into the VNET, as vnet1-admin, and run the running-config-show command:

CLI vnet1-admin@switch > running-config-show

storage-pool-create name pool-disk2 device1 disk2

storage-pool-create name test

vnet-manager-modify name vnet1-mgr enable

vnet-manager-service-modify vnet-manager-name vnet1-mgr if eth0 web

storage-hapool-create name hapool1 local-pool pool-di hapool-peer-pool

pool-disk4 backup-interval 1m