S Commands

service-heartbeat-create

Netvisor generates a packet from the CPU to send to the receive port of an Inline Service and the Netvisor vFlow configured for snooping is not port-specific, as Netvisor accepts the response from either the receive port or the transmit port. You configure the heartbeat as an additional parameter for a specific Inline Service.

Syntax   service-heartbeat-create

i

name name-string

Specify the name for the Heartbeat Service.

interval duration: #d#h#m#s

Specify the interval between heartbeat packets.

retry retry-number

Specify the number of times to retry sending a packet.

vlan vlan-id5

Specify a VLAN ID.

src-mac mac-address

Specify the source port MAC address.

dst-mac mac-address 

Specify the destination MAC address.

type normal|pass-through

Specify the type of heartbeat response as normal or passthrough. A normal response indicates that the Inline Service sends the response. A passthrough response indicates that Netvisor sends the response and returns it to the Inline Service.

payload payload-string

Specify the payload for the heartbeat packet.

Syntax

Defaults   None

Access   Network Administrator

History   Command introduced in Version 2.6.0.

Usage   Use this command to create a Heartbeat Service configuration.

Examples  To create a Heartbeat Service, use the following syntax:

CLI network-admin@switch > service-heartbeat-create name FW_probe interval 5s retry 3 vlan-id 10 src-mac 64:6e:11:1c:11:11 dst-mac 01:1b:11:01:01:01 type normal payload 54 63 82 ff 01 46 12 ce a2 d4 00 00 00 00 00 00 00 00

See Also