This command is used to display basic setup parameters for a switch.

Syntax   switch-route-show

network ip-address

Displays the destination IPv4 or IPv6 address.

netmask netmask

Displays the destination netmask.

Specify one or more of the following options:

gateway-ip ip-address

Displays the gateway IPv4 or IPv6 address.

nic switch-nic nic

Displays the NIC.

metric integer

Displays the metric for the route as an integer between 1 and 4294967295.

Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.


Display output in ascending order.


Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.


Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.


Display the number of entries in the output. This is useful with vRouter show commands.


Display full values in the output instead of scaled approximate values.


Display integer values instead of mapped values


Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.

Defaults   None.

Access   CLI


Version 2.3.0

Command introduced.

Version 3.0

The parameter, metric, added.

Usage   This command is useful for Layer 3 communication on the fabric.

Examples  To display basic parameters, use the following command:

CLI network-admin@switch > switch-route-show

See Also