This command is used to modify an existing tunnel on the switch.

Syntax   tunnel-modify scope local name name-string local-ip ip-address remote-ip ip-address [router-if vrouter-hw-if name] [next-hop ip-address] [next-hop mac-address]

name name-string

Specify the name of the tunnel.

Specify one or more of the following options:

scope local

Specify the scope for the tunnel. Only local scopes are supported.

local-ip ip-address

Specify the local IP address.

remote-ip ip-address

Specify the remote IP address.

next-hop ip-address

Specify the next hop IP address.

next-hop mac-address

Specify the next hop MAC address.


Specify BFD for the tunnel.

Defaults   None.

Access   CLI


Version 1.2

Command introduced.

Version 2.1

The parameters, type and remote-switch, deprecated.

Version 2.2.3

The parameter router-if replaced name-string with vrouter-hw-if name option.

Version 3.0.0

The parameter, vrouter-if, deprecated. The parameter, bfd, added.

Usage   Tunnels are used to encapsulate unsupported protocols on a network. Use this command to modify tunnels on a fabric.

Examples  To modify the local IP address to, use the following command:

CLI network-admin@switch > tunnel-modify scope local name tunnel010 local-ip

See Also