This command removes an existing port from a VLAN.

Syntax   vlan-port-remove vlan-id vlan-id vlan-vnet vnet-name [switch switch-name] ports port-list

vlan-id vlan-id

Specifies the identifier of the VLAN in the range from 2 to 4092.

vlan-range vlan-list

Specify the range of VLAN IDs.

vlan-vnet vnet-name

Specify the name of the VNET assigned to the VLAN.

Specify the following port arguments:

switch switch-name

Specify the name of the switch with the port.

ports port-list

Specifies the switch network data port number, list of ports, or range of ports. Port numbers must be in the range of 1 to 64.

Defaults   None.

Access   CLI


Version 1.2

Command introduced.

Version 2.4.1

The parameter, vnet, added.

Version 3.0.0

The parameter, vlan-range, added.

Usage   VLANs can be used to isolate network traffic at Layer 2. This command creates a new VLAN..


Informational Note:  The VLAN identifiers 0 and 4095 are reserved and cannot be used per the IEEE 802.1Q standard.

The range of configurable VLAN identifiers is 2 through 4092.

Examples  To remove ports 17 and 18 from VLAN 7 and VNET, finance-1, use the following command:

CLI network-admin@switch > vlan-port-remove vlan-id 7 vnet finance-1 ports 17,18

See Also