vrouter-packet-relay-show

This command is used to display information about a packet forwarding configuration.

Syntax   vrouter-packet-relay-show vrouter-name name-string forward-proto dhcp forward-ip ip-address nic vrouter interface nic

vrouter-name name-string

Specifies the name of the vRouter.

Specify the following packet relay arguments:

forward-proto dhcp

Specifies the forwarding protocol.

forward-ip ip-address

Specifies the IP address to forward packets.

nic vrouter interface nic

Specifies the interface of the vRouter.

Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.

sort-asc

Display output in ascending order.

sort-desc

Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.

show-headers|
no-show-headers

Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.

count-output

Display the number of entries in the output. This is useful with vRouter show commands.

unscaled

Display full values in the output instead of scaled approximate values.

raw-int-values

Display integer values instead of mapped values

sum-by

Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.

Defaults   None

Access   CLI

History   Command introduced in Version 2.2.3.

Usage   Using the vrouter-packet-relay command configures the Layer3 interface which receives the client’s DHCP broadcast. You can change the broadcast request into a unicast and send it to a centralized DHCP server that is located to a different subnet in your network. The unicast DHCP request is normally routed to the destination DHCP Server within the network, even if the server is far away from the DHCP client.

Examples  To remove the configuration with a DHCP server with the IP address, 10.30.21.11, and vRouter interface eth0, use the following syntax:

CLI network-admin@switch > vrouter-packet-relay-show vrouter-name vrouter-dhcp forward-proto dhcp forward-ip 10.30.21.11 nic eth0

See Also   

vrouter-packet-relay-add

vrouter-packet-relay-remove