vtep-show

Previous versions of Netvisor required configuring a tunnel from every node in the fabric and manually adding VNIs to them. Also, when a new VTEP is added to the fabric, there is no notification about this event, and requires manually creating tunnels from the new node to all other nodes in the fabric. VTEP commands are used to automatically create tunnels between nodes in a fabric.

Syntax   vtep-show scope fabric name name-string location fabric-node name vrouter-name vrouter-name ip ip-address virtual-ip ip-address 

scope fabric

Display the VTEP scope.

name name-string

Display a name for the VTEP.

location fabric-node-name

Display the location of the switch.

vrouter-name name-string

Display the name of the vRouter service.

ip ip-address

Display the primary IP address.

virtual-ip ip-address

Display the virtual IP address.

 

Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.

sort-asc

Display output in ascending order.

sort-desc

Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.

show-headers|
no-show-headers

Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.

count-output

Display the number of entries in the output. This is useful with vRouter show commands.

unscaled

Display full values in the output instead of scaled approximate values.

raw-int-values

Display integer values instead of mapped values

sum-by

Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.

Defaults   None

Access   network-admin

History   Command introduced in Version 2.6.0.

Usage   Use this command to display information about a VTEP configuration.

Examples  To display information about VTEP configuration on Spine 1, use the following syntax:

CLI network-admin@switch > vtep-show

See Also