Example: Configuring a Fabric for Virtual Wire Switches

The configuration example in this section refers to a Virtual Wire fabric composed by one spine and two leaf switches as in Figure 8. Two devices, device-A and device-B, have respectively two ports and one port that are physically connected to the Virtual Wire switch Leaf-1. A third device, device-C, is physically connected to the Virtual Wire switch Leaf-2. The desired logical setup consists in a bidirectional service chain topology where device-A is inserted in-line between device-B and device-C.

Figure 8: Bidirectional Traffic over a Virtual Wire Connection

birectional-traffic-VW.png

To create a bidirectional virtual link from device-A to device-C, use these steps:

1. Configure a port association for device-A to device-C using port 1 and port 45 on Leaf-1.

network-admin@Leaf-1>port-association-create name link-AC virtual-wire bidir master-ports 1 slave-ports 45

2. Configure a port association on Spine-1 between ports 1 and 2:

network-admin@Spine-1>port-association-create name link-AC virtual-wire bidir master-ports 1 slave-ports 2

3. Configure a port association on Leaf-2 between ports 45 and 1:

network-admin@Leaf-2>port-association-create name link-AC virtual-wire bidir master-ports 45 slave-ports 1

4. Configure a port association from device-A to device-B:

network-admin@Leaf-1>port-association-create name link-AB virtual-wire bidir master-ports 2 slave-ports 3