Prerequisites

Please refer to Adding License Keys to Netvisor in this guide for how to install a license on the switch.

Virtual Wire functionality is available for any supported Pluribus Network transceiver at 1Gbs/10Gbs/40Gbs. For a list of supported transceivers please refer to the product datasheet.

All commands described in this chapter require a management fabric. Information on how to create or join a management fabric is available in section Introduction to Netvisor Fabric.

To add the Virtual Wire feature to an existing Pluribus Networks switch in your network, you must use the switch-config-reset command to erase the current configuration. Then, after reconfiguring the initial setup, you must upgrade to the latest version of Netvisor that supports Virtual Wire mode. And then, install the license key for Virtual Wire.


 

Informational Note:  Before using the REST APIs described in this document, be sure to set up Swagger as your REST API reference.Refer to the instructions in the Configuring REST API Clients chapter. To use the REST API feature, you must enable the Web service on the switch using the command, admin-service-modify web on.