igmp-querier-ip-show

You can configure an IGMP querier IP address for a VLAN or as a global IGMP querier. The IGMP querier sends IGMP General Query messages. on the network.

If no querier IP address is specified, then 0.0.0.0 is the default value. There can be an unique querier IP for each VLAN, or you can configure the same Querier IP address for all the VLANs participating in IGMP snooping. The Querier IP address should have a local scope and every switch should have a unique Querier IP address.

With a valid source IP address on IGMP Query packets, the VLAN, where Query is received, is added to an IGMP Snoop switch list, and is now reflected in the igmp-switches-show output and the IGMP queries are sent to the peer Switch as well. This is to solicit a report from the hosts listening on the peer switch.

Syntax   igmp-querier-ip-show querier-ip ip-address vlans-on-querier-ip vlan-list

querier-ip ip-address

Specify the Snooping Querier IP address.

vlans-on-querier-ip vlan-list

Specify the VLAN map for the querier IP address.

Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.

sort-asc

Display output in ascending order.

sort-desc

Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.

show-headers|
no-show-headers

Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.

count-output

Display the number of entries in the output. This is useful with vRouter show commands.

unscaled

Display full values in the output instead of scaled approximate values.

raw-int-values

Display integer values instead of mapped values

sum-by

Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.

Defaults   None

Access   network-admin

History   Command introduced in Version 2.5.

Usage   Display an IGMP querier IP address for a VLAN or as a global IGMP querier.

Examples  To display an IGMP querier IP address with a VLAN list of 12-15, use the following syntax:

CLI network-admin@switch > igmp-querier-ip-show querier-ip 1.1.1.1 vlans-on-querier-ip 12-15