igmp-static-group-create

This command creates a static IGMP group on the network..


 

Informational Note:  IGMPv1 is not supported in nvOS. If you are using IGMPv1, you must disable IGMP snooping on the Pluribus Networks switch.

 

Syntax   igmp-static-group-create [group-ip ip-address] [vlan vlan-id] [ports port-list]

group-ip ip-address

Speicifies the group multicast IP address for IGMP.

vlan vlan-id

Specifies the VLAN identifier.

ports port-list

Specifies the list of ports.

Defaults   None

Access   CLI

History   Command introduced in nvOS Version 1.2.1.

Usage   IGMP groups are used to determine the reception state for a specific multicast address. This allows the switch to determine if any switches need messages sent from a multicast group. Use this command to create an IGMP static group.

Examples  To configure a static group for 239.4.9.3 on VLAN 202 and ports 55-57, use the following command:

CLI network-admin@switch > igmp-static-group-create group-ip 239.4.9.3 vlan 202 ports 55-57

See Also   

igmp-show

igmp-snooping-modify

igmp-snooping-show

igmp-static-group-create

igmp-static-group-delete

igmp-static-source-delete

igmp-static-source-show