igmp-static-source-create

This command creates a static IP address as the IGMP source on the network..


 

Informational Note:  IGMPv1 is not supported in nvOS. If you are using IGMPv1, you must disable IGMP snooping on the Pluribus Networks switch.

 

Syntax   igmp-static-source-create [source-ip ip-address][group-ip ip-address] [vlan vlan-id] [vnet vnet-name] [ports port-list]

source-ip ip-address

Specify the source IP address. This is a unicast IP address.

group-ip ip-address

Specify the group IP address for IGMP.

vlan vlan-id

Specify the VLAN identifier.

Specify the following option:

vnet vnet-name

Specify the name of the VNET assigned to the IGMP static source.

l2-net l2-net name

Specify the group Layer 2 network.

ports port-list

Specify the list of ports.

Defaults   None

Access   CLI

History   

Version 1.2

Command introduced.

Version 2.4.1

The parameter, vnet, added.

Version 3.0.0

The parameter l2-net added.

Usage   IGMP groups are used to determine the reception state for a specific multicast address. This allows the switch to determine if any switches need messages sent from a multicast group. Use this command to create an IGMP static IP address as the source.

Examples  To add the static source 12.0.0.1 as the static source, use the following command:

CLI network-admin@switch > igmp-static-source-create source-ip 12.0.0.1 group-ip vlan 202 ports 55-57

See Also   

igmp-show

igmp-snooping-modify

igmp-snooping-show

igmp-static-group-create

igmp-static-group-delete

igmp-static-source-delete

igmp-static-source-show