igmp-static-source-show

This command displays a static IGMP source on the network.


 

Informational Note:  IGMPv1 is not supported by Pluribus Networks. If you are using IGMPv1, you must disable IGMP snooping on the Pluribus Networks switch.

Syntax   igmp-static-source-show [group-ip ip-address] [vnet vnet-name] [vlan vlan-id] [source-ip ip-address] [host-ip ip-address] [ports port-list]

group-ip ip-address

Specifies the group IP address for IGMP.

vnet vnet-name

Specify the name of the VNET assigned to the IGMP static source.

source-ip ip-address

Specifies the source IP address.

host-ip ip-address

Specifies the host IP address

vlan vlan-id

Specifies the VLAN identifier.

ports port-list

Specifies the list of ports.

Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.

sort-asc

Display output in ascending order.

sort-desc

Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.

show-headers|
no-show-headers

Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.

count-output

Display the number of entries in the output. This is useful with vRouter show commands.

unscaled

Display full values in the output instead of scaled approximate values.

raw-int-values

Display integer values instead of mapped values

sum-by

Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.

Defaults   None

Access   CLI

History   

Version 1.2

Command introduced.

Version 2.4.1

The parameter, vnet, added.

Usage   IGMP groups are used to determine the reception state for a specific multicast address. This allows the switch to determine if any switches need messages sent from a multicast group. Use this command to remove an IGMP static source.

Examples  To display information about all IGMP static source IP addresses, use the following command:

CLI network-admin@switch > igmp-static-source-show

See Also   

igmp-show

igmp-snooping-modify

igmp-snooping-show

igmp-static-group-create

igmp-static-group-delete

igmp-static-source-delete

igmp-static-source-show