ip-pool-modify

This command modifies an IP address pool with a specific IP address range.

Syntax   ip-pool-modify name ip-pool-name start-ip ip-address end-ip ip-address netmask netmask [vlan vlan-id]

name ip-pool-name

Specify the name of the IPpol.

Specify one or more of the following options:

start-ip ip-address

Specify the first IP address in the pool. This address is included in the pool.

end-ip ip-address

Specify the end IP address of the pool and is included in the pool.

network

ip-address

Specify the network for the IP address pool, for example, 192.168.1.0.

netmask netmask

Specify the subnet for the IP address pool.

l2-net l2-net-name

Specify the name of the Layer 2 network.

vlan vlan-id

Specify the VLAN identifier for an IP address pool that applies to a specific Layer 2 network segment.

Defaults   None

Access   CLI

History   

Version 1.2

Command introduced.

Version 2.2

The parameter, vnet, deprecated.

Version 3.0.0

The parameter, l2-net, added.

Usage   IP address pools help automate the management of IP addresses for hosts and virtual machines, including the management IP addresses of the switches in a fabric. Use this command to modify an existing IP pool.

Examples  To modify a fabric-wide IP address pool named MyPublicIPv4Pool to automate the allocation of IP addresses within a fabric for the IP address block 208.74.182.0/24 to 208.74.182.201/24, use the following command:

CLI network-admin@switch > ip-pool-modify name MyPublicIPv4Pool start-ip 208.74.182.0 end-ip 208.74.182.200 netmask 255.255.255.0

See Also   

ip-pool-create

ip-pool-delete

ip-pool-show