This command displays information about an IP address pool with a specific IP address range.

Syntax   ip-pool-show name ip-pool-name vnet vnet-name scope local|fabric start-ip ip-address end-ip ip-address network ip-address netmask netmask [vlan vlan-id]

name ip-pool-name

Specifies the name of the IP pool.

vnet vnet-name

Specifies the VNET for the IP pool.

scope local|fabric

Specifies the scope of the VNET.

start-ip ip-address

Specifies the first IP address in the pool. This address is included in the pool.

end-ip ip-address

Specifies the end IP address of the pool and is included in the pool.

network ip-address

Specify an IP address group such as

netmask netmask

Specifies the subnet for the IP address pool.

l2-net l2-net-name

Specify the name of the Layer 2 network.

vlan vlan-id

Specifies the VLAN identifier for an IP address pool that applies to a specific Layer 2 network segment.

Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.


Display output in ascending order.


Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.


Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.


Display the number of entries in the output. This is useful with vRouter show commands.


Display full values in the output instead of scaled approximate values.


Display integer values instead of mapped values


Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.

Defaults   None

Access   CLI


Version 1.2

Command introduced.

Version 2.2

The parameter, vnet, deprecated.

Version 3.0.0

The parameter, l2-net, added.

Usage   IP address pools help automate the management of IP addresses for hosts and virtual machines, including the management IP addresses of the switches in a fabric.

Examples  To display information about a fabric-wide IP address pool named vPool, use the following command:

CLI network-admin@switch > ip-pool-show name vPool

Name   Owner   Scope   Range Start    Range End      Nemask   Gateway   DNS

vPool  None    local 24  0

See Also