l2-setting-modify

This command modifies the Layer 2 settings in the configuration.

Syntax   l2-setting-modify aging-time seconds software-aging|no-software-aging] l2-checker|no-l2-checker l2-checker-interval duration: #d#h#m#s

aging-time seconds

Configures the aging time in Layer 2. You can configure a value from 1 to 2000000. The default value is 300 seconds.

software-aging|
no-software-aging

Specify if you want to enable software aging or not. This is ON by default. This parameter controls how the aging of the L2 table entries is performed by Netvisor. When OFF, the aging is performed by the Ethernet switch ASIC. It is not recommended to change this setting.

l2-checker|no-l2-checker

Specify if you want to enable Layer 2 checker.

l2-checker-interval duration: #d#h#m#

Specify the interval between Layer 2 checks.

l3-arp-max-count l3-arp-max-count-number

Specify the number of maximum ARPs for Layer 3 entries.

 

Defaults   None.

Access   CLI

History   

Version 1.2

Command introduced.

Version 2.4

The parameters, software-aging, l2-checker and l2-checker-interval added.

Usage   Use this command to modify the Layer 2 aging time in seconds.

Examples  To modify the aging time to 360 seconds, use the following command:

CLI network-admin@switch > l2-setting-modify aging-time 360

See Also   

l2-history-show

l2-setting-show

l2-table-flush

l2-table-show