l3-setting-modify

This command allows you to modify the Layer 3 settings.

Syntax   l3-setting-modify aging-time seconds

Specify one or more of the following options:

aging-time

Specifies the aging time between 0 to 2000000 seconds. Use 0 (zero) to disable aging time. The default aging time is 600 seconds.

convergence-time seconds

Specifies the unicast convergence time on bootup. This is a value from 0 to 3600 seconds.

l3-checker|
no-l3-checker

Enable or disable Layer 3 checking.

l3-checker-interval duration: #d#h#m#

Specify the interval between Layer 3 checks.

l3-checker-fix|
no-l3-checker-fix

Specify if after checking Layer 3 entries to fix the incorrect entries.

Defaults   None

Access   CLI

Usage   Use this command to modify the Layer 3 setting.

Examples  To modify the Layer 3 aging-time setting, use the following command:

CLI network-admin@switch > l3-setting-modify aging-time 1000

CLI network-admin@switch > l3-setting-show format all

switch:        spine-1

aging-time(s): 1000