Port LACP

port-lacp-modify

This command allows you to run a port configured with LACP in test mode.

Syntax   port-lacp-modify [port port-list] [test-mode none|no-tx|no-rx|no-rx-or-tx]

port port-list

Specifies the switch network data port number, list of ports, or range of ports. Port numbers must be in the range of 1 to 64.

test-mode none|no-tx|no-rx|
no-rx-or-tx

Specify the test mode for the port.

Defaults   None

Access   CLI

History   Command introduced in Version 1.2.2.

Usage   Use this command to modify a port and run it in test mode.

Examples  To modify port 54 and place it in test mode, no-tx, use the following command:

CLI network-admin@switch > port-lacp-modify port 54 test-mode no-tx

 

See Also   

port-config-modify

port-config-show

port-config-modify

port-phy-show

port-stats-clear

port-stats-show

port-vlan-add

port-vlan-remove

port-vlan-show

port-xcvr-show