vrouter-static-bfd-show

Netvisor provides support for static route reachability detection using Bidirectional Forwarding Detection (BFD) protocol. A static route entry is installed in the Routing Information Database (RIB) only if BFD is able to communicate with the gateway. After installation, BFD periodically monitors reachability and removes the route if connectivity is lost.

IPv4 and IPv6 addresses are both supported.

Syntax   vrouter-static-bfd-show vrouter-name name-string src-ip ip-address dst-ip ip-address type single-hop|multi-hop

vrouter-name name-string

Displays the name of the vRouter service configuration to add BFD

the following static-bfd arguments:

src-ip ip-address

Displays the source IPv4 or IPv6 address for the BFD session.

dst-ip ip-address

Displays the destination IPv4 or IPv6 address for the BFD session.

type single-hop|multi-hop

Displays the BFD type.

Defaults   None

Access   Network Administrator

History   Command introduced in Version 2.5.3.

Usage   Use this command to display information about BFD and a static route.

Examples  To display BFD information about a static route,on vRouter, static-1, with a source IP address, 172.21.16.45, and destination IP address, 10.1.1.101, with multiple hops, use the following syntax:

CLI network-admin@switch > vrouter-static-bfd-show vrouter-name static-1 src-ip 172.21.16.45 dst-ip 10.1.1.101 type multihop

See Also