Virtual Router and Vtysh


Display Quagga show output using the Netvisor CLI.

Syntax   vrouter-vtysh-cmd name name-string cmd cmd-string

name name-string 

Specify the name of the vRouter service configuration.

cmd cmd-string

Specify any Quagga show/debug/undebug/no debug command.

Defaults   None

Access   Network Administrator

History   Command introduced in Version 2.5.3.

Usage   Use this command to display information on Quagga show or debug output.

Examples  To display information about IP routing, use the following syntax:

CLI (network-admin@Spine1) > vrouter-vtysh-cmd name vr1 cmd "show ip route"

Codes: K - kernel route, C - connected, S - static, R - RIP,

      O - OSPF, I - IS-IS, B - BGP, P - PIM, A - Babel,

       > - selected route, * - FIB route


C>* is directly connected, eth1.100

C>* is directly connected, lo0