vtep-create

Previous versions of Netvisor required configuring a tunnel from every node in the fabric and manually adding VNIs to them. Also, when a new VTEP is added to the fabric, there is no notification about this event, and requires manually creating tunnels from the new node to all other nodes in the fabric. VTEP commands are used to automatically create tunnels between nodes in a fabric.

Syntax   vtep-create name name-string location fabric-node name vrouter-name vrouter-name ip ip-address virtual-ip ip-address 

name name-string

Specify a name for the VTEP.

location fabric-node-name

Specify the location of the switch.

vrouter-name name-string

Specify the name of the vRouter service.

ip ip-address

Specify the primary IP address.

virtual-ip ip-address

Specify the virtual IP address.

 

Defaults   None

Access   network-admin

History   Command introduced in Version 2.6.0.

Usage   Use this command to create about a VTEP on a switch.

Examples  To create a VTEP on Spine 1, use the following syntax:

CLI network-admin@Spine1>vtep-create name vtep1 ip 10.10.10.1 vrouter-name VR1

 

See Also