Previous versions of Netvisor required configuring a tunnel from every node in the fabric and manually adding VNIs to them. Also, when a new VTEP is added to the fabric, there is no notification about this event, and requires manually creating tunnels from the new node to all other nodes in the fabric. VTEP commands are used to automatically create tunnels between nodes in a fabric.

Syntax   vtep-vxlan-show name name-string vxlan vxlan-id

name name-string

Specify the name of the VTEP.

vxlan vxlan-id

Specify the VXLAN identifier.


Formatting Options

format fields-to-display

Display output using a specific parameter. Use all to display all possible output.

parsable-delim character

Display output formatted for machine parsing using a specified delimiter.


Display output in ascending order.


Display output in descending order.

show dups

Display duplicate entries in the output.

layout vertical|horizontal

Format the output in a vertical or horizontal layout.

show-interval seconds-interval

Repeat the show command at a specified interval.


Display column headers or not.

limit-output number

Limit the display output to a specific number of entries.


Display the number of entries in the output. This is useful with vRouter show commands.


Display full values in the output instead of scaled approximate values.


Display integer values instead of mapped values


Aggregate output by specific parameters. If sum-by fields are specified, records that have the same value in sum-by fields are combined and displayed as one aggregate record. NOTE: This option is only available for show commands that collect statistics such as connection-stats-show.


Defaults   None

Access   network-admin

History   Command introduced in Version 2.6.0.

Usage   Use this command to display VXLANs added to a VTEP on a switch.

Examples  To display VXLANs on VTEP1 on Spine 1, use the following syntax:

CLI network-admin@Spine1>vtep-vxlan-show vtep-name vtep1 vxlan 10000


See Also