About the Spanning Tree Protocol (STP) in Cluster Mode
In cluster mode Netvisor ONE ensures that the two physical cluster nodes behave as one single logical spanning tree node.
It achieves this by automatically sharing across both devices the same STP bridge ID and STP priorities, and by using dedicated and disjoint STP port ID ranges: STP port IDs on the primary node are 0 to PORTS_MAX – 1 whereas on the secondary node are PORTS_MAX to (2*PORTS_MAX - 1). This happens regardless of the online/offline state of the cluster and thus guarantees protocol ID consistency/persistency and a seamless failover in case of node failure.
In addition, in case of active-active vLAGs (that is, dual-homed links), Netvisor ONE makes sure that they behave as single logical ports in the STP state machine. For this purpose, rather than creating a new port ID range for these logical ports, the master uses its local STP port ID as the logical port ID (which is preserved across failovers). Therefore, in case of single vLAG member link failure no STP reconvergence occurs. (Please note that with active-standby vLAGs a single link failure can cause an STP topology change.)
If an entire cluster node fails and therefore the cluster goes offline, STP will run the STP state machine locally and independently from the (down) peer. This is therefore called independent mode.
Then, when the cluster comes back online and needs to run in STP cluster mode, as mentioned in the previous section, the cluster synchronization process is employed to elect a master node (with the non-elected peer becoming the slave).
Only the master node runs the STP state machine, which encompasses all VLANs and all ports, both local (on the master switch) and remote on the slave switch (cluster links are excluded and are managed separately, as described in a subsequent paragraph).
The master’s STP state machine, user configuration changes (of the STP mode, MSTP instances, bridge ID, etc.) and vLAG port states are mirrored to the slave node so that, if the master fails, the slave can seamlessly take over from where the master left off.
In conjunction with the ownership of the STP state machine, it’s required for the master switch to manage the very important BPDU transmission function, even for any (single-homed) ports belonging to the slave switch. Not all the aggregate burden of this function falls on the master node, though: the slave switch provides some basic PDU relay support to the master to ensure proper load splitting of this function and hence optimal scalability when running in STP cluster mode. In addition, the slave relays to the master all BPDUs it may directly receive.
As for cluster links, they follow specific STP state transitions: when a cluster goes online, the cluster links start in STP blocked state (except for VLAN 4094 used for synchronization) to prevent loops. However, once the state from the newly elected master gets fully synchronized to its slave, the cluster links are put into STP forwarding state to provide a back-up forwarding path for traffic.
In special cases in which the transmission of the synchronization messages from the master to the slave fails (or times out), the cluster links are put back into the STP blocking state until synchronization can complete to avoid potential loops.
If the master node goes offline, the slave will continue running the STP state machine from the last mirrored state. If the former master then comes back online, it is then selected to become the slave and the state of the node that was already up is mirrored to it.
In this way, there is never any interruption in STP state preservation even after multiple failures of either node, as long as one node is always up.