Configuring Layer 3 Features > > Support for Displaying FRR Routing and Debug Information for vRouters
Was this helpful?
Support for Displaying FRR Routing and Debug Information for vRouters
This feature provides a vRouter command to display the output of IP Stack (FRR) routing and debug information from the Netvisor ONE command line interface(CLI).
CLI (network-admin@Spine1) > vrouter-vtysh-cmd
vrouter-vtysh-cmd display vrouter FRR command
name name-string name of service config
cmd cmd-string   any FRR show/debug/undebug/no debug/clear ip/clear ipv6 command
 
Show Output Examples
CLI (network-admin@Spine1) > vrouter-vtysh-cmd name vr1 cmd "show ip route"
Codes: K - kernel route, C - connected, S - static, R - RIP,
O - ONEPF, I - IS-IS, B - BGP, P - PIM, A - Babel,
> - selected route, * - FIB route
 
C>* 100.1.1.0/24 is directly connected, eth1.100
C>* 127.0.0.0/8 is directly connected, lo0
 
CLI (network-admin@Spine1) > vrouter-vtysh-cmd name vr1 cmd "show running-config"
Building configuration...
 
Current configuration:
!
hostname vr1
log file zebra.log
!
password zebra
enable password zebra
!
interface eth1.100
ipv6 nd suppress-ra
multicast
no link-detect
!
interface lo0
no link-detect
!
ip forwarding
ipv6 forwarding
!
line vty
!
end
 
For this feature, Netvisor ONE only allows show commands as legal values in the CLI.
CLI network-admin@Leaf1 > vrouter-vtysh-cmd name vr1 cmd "config t"
vrouter-vtysh-cmd: Illegal value for "cmd"
vrouter-vtysh-cmd: Legal values: commands starting with show, in quotes