Using Port Buffering
Netvisor ONE enables you to display and modify the port buffering settings for the switch ports. To display the port buffering settings, use the port-buffer-settings-show command:
CLI network-admin@Leaf1 > port-buffer-settings-show
switch: Spine1
enable: yes
interval: 1m
disk-space: 50M
 
To modify port buffering settings, use the port-buffer-settings-modify command:
CLI network-admin@Leaf1 > port-buffer-settings-modify interval 2m
Modify the buffer interval, duration, disk space, and enable or disable port buffering on the switch.
To display the port buffer, use the port-buffer-show command:
CLI network-admin@Leaf1 > port-buffer-show
switch: Spine1
port: 0
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Spine1
port: 3
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Pleiades24
port: 57
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Spine1
port: 65
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Spine2
port: 0
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Spine2
port: 1
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0