Was this helpful?
Using Port Buffering
Netvisor ONE enables you to display and modify the port buffering settings for the switch ports. To display the port buffering settings, use the port-buffer-settings-show command:
CLI network-admin@Leaf1 > port-buffer-settings-show
switch: Spine1
enable: yes
interval: 1m
disk-space: 50M
 
To modify port buffering settings, use the port-buffer-settings-modify command:
CLI network-admin@Leaf1 > port-buffer-settings-modify interval 2m
Modify the buffer interval, duration, disk space, and enable or disable port buffering on the switch.
To display the port buffer, use the port-buffer-show command:
CLI network-admin@Leaf1 > port-buffer-show
switch: Spine1
port: 0
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Spine1
port: 3
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Pleiades24
port: 57
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Spine1
port: 65
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Spine2
port: 0
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0
switch: Spine2
port: 1
ingress-used-buf: 0%
ingress-used-buf-val: 0
egress-used-buf: 0%
egress-used-buf-val: 0