Prerequisites


Please refer to Adding License Keys to Netvisor One in this guide for how to install a license on the switch.


Virtual Wire functionality is available for any supported Pluribus Network transceiver at 1Gbs/10Gbs/40Gbs.


For a list of supported transceivers please refer to the product datasheet.


All commands described in this chapter require a management fabric. Information on how to create or join a management fabric is available in section Introduction to Netvisor One Fabric.


To add the Virtual Wire feature to an existing Pluribus Networks switch in your network, you must use the switch-config-reset command to erase the current configuration.


After reconfiguring the initial setup, you must upgrade to the latest version of Netvisor One that supports Virtual Wire mode. And then, install the license key for Virtual Wire.