Prerequisites


Please refer to Adding License Keys to Netvisor One in this guide for how to install a license on the switch.


VirtualWire functionality is available for any supported Pluribus Network transceiver at 1Gbs/10Gbs/40Gbs.


For a list of supported transceivers please refer to the product data sheet.


All commands described in this chapter require a management fabric. Information on how to create or join a management fabric is available in the section Introduction to Netvisor One Fabric.


To add the VirtualWire feature to an existing Pluribus Networks switch in your network, you must use the switch-config-reset command to erase the current configuration.


After re-configuring the initial setup, you must upgrade to the latest version of Netvisor One that supports VirtualWire mode. And then, install the license key for VirtualWire.