bezel-portmap-show
This port is used to display physical to logical port mapping on the Dell platform. All port are 40G ports that can be split into 4 logical 10G ports.
Syntax bezel-portmap-show port port bezel-intf number
|
port port |
Specify a logical port. |
|
bezel-intf number |
Specify an interface number. |
Defaults None
Access network-admin
Usage Use this command to display the physical to logical port mapping on a Dell platform.
Examples To display port mapping on the Dell platform, use the following syntax:
CLI network-admin@switch > bezel-portmap-show
switch port bezel-intf
------- ---- ----------
s6000-2 1 1
s6000-2 2 1.2
s6000-2 3 1.3
s6000-2 4 1.4
s6000-2 5 2
s6000-2 6 3
s6000-2 7 3.2
s6000-2 8 3.3
s6000-2 9 3.4
s6000-2 10 4
s6000-2 11 5
s6000-2 12 5.2
s6000-2 13 5.3
s6000-2 14 5.4
s6000-2 15 6
s6000-2 16 7
s6000-2 17 7.2
s6000-2 18 7.3
s6000-2 19 7.4
From the output above, you can determine that port 1 has no cables connected to it. However port 2, has a 40G cable connected to another switch on the network. This is indicated by a single port number instead of 4 port numbers.