igmp-static-group-show
This command is used to display information about IGMP static groups configured on the switch.
Informational Note: IGMPv1 is not supported in nvOS. If you are using IGMPv1, you must disable IGMP snooping on the Pluribus Networks switch.
Syntax igmp-static-group-show
|
group-ip ip-address |
Specifies the IP address of the IGMP static group. |
|
vnet vnet-name |
Specifies the VNET assigned to the IGMP static group. |
|
l2-net l2-net name |
Specify the group Layer 2 network. |
|
vlan vlan-id |
Specifies the VLAN assigned to the IGMP static group. |
|
ports port-list |
Specifies the ports assigned to the IGMP group. |
Access CLI
History
|
Version 2.0 |
Command introduced. |
|
Version 2.4.1 |
The parameter, vnet, added. |
|
Version 3.0.0 |
The parameter l2-net added. |
Usage IGMP groups are used to determine the reception state for a specific multicast address. This allows the switch to determine if any switches need messages sent from a multicast group. Use this command to display an IGMP static group.
Examples To display a static group for 239.4.9.3 on VLAN 202 and ports 55-57, use the following command:
CLI network-admin@switch > igmp-static-group-show group-ip 239.4.9.3 vnet global-fab vlan 202 ports 55-57