l2-setting-modify
This command modifies the Layer 2 settings in the configuration.
Syntax l2-setting-modify
|
aging-time seconds |
Configures the aging time in Layer 2. You can configure a value from 1 to 2000000. The default value is 300 seconds. |
|
software-aging|no-software-aging |
Specify if you want to enable software aging or not. This is ON by default. This parameter controls how the aging of the L2 table entries is performed by Netvisor. When OFF, the aging is performed by the Ethernet switch ASIC. It is not recommended to change this setting. |
|
l2-max-count l2-max-count-number |
Specify the maximum count for Layer 2 entries. |
|
l2-checker|no-l2-checker |
Specify if you want to enable Layer 2 checker. |
|
l2-checker-interval duration: #d#h#m# |
Specify the interval between Layer 2 checks. |
|
l3-arp-max-count l3-arp-max-count-number |
Specify the number of maximum ARPs for Layer 3 entries. |
Defaults None.
Access CLI
History
|
Version 1.2 |
Command introduced. |
|
Version 2.4 |
The parameters, software-aging, l2-checker and l2-checker-interval added. |
|
Version 5.1.1 |
The parameter, l2-max-count, added. |
Usage Use this command to modify the Layer 2 aging time in seconds.
Examples To modify the aging time to 360 seconds, use the following command:
CLI network-admin@switch > l2-setting-modify aging-time 360