l3-check-fix
Layer 3 entries can become unsynchronized between the software table and the hardware table. When routes are modified while the routes are updating on the network, this can occur. Use this command to fix any unsynchronized Layer 3 table entries.
Syntax l3-check-fix
|
vrid ID |
Specifies the virtual router ID from 0 to 15. |
|
ip ip-address |
Specifies the IP address of the entry. |
|
prelen length |
Specifies the prefix length from 0 to 128. |
|
vnet vnet-name |
Specify the vNEt name |
|
bd bridge-domain-name |
specify the bridge domain name. |
|
vlan vlan-id |
Specifies the VLAN ID. |
|
mac mac-address |
Specifies the MAC address. |
|
fix-action none|add-host-to-hardware|remove-host-from-hardware| re-add-host-to-hardware|add-route-to-hardware|remove-route-from-hardware|re-add-route-to-hardware| none-hardware-only-route|none-cached-route| FAILED-add-host-to-hardware|FAILED-remove-host-from-hardware|FAILED-add-route-to-hardware|FAILED-remove-route-from-hardware |
Specifies the action used to fix the entry. |
Defaults None
Access CLI
History Command introduced in Version 2.5.
Usage Use this command to fix Layer 3 entries that are out of synch in the Layer 3 table.
Examples Use the following syntax to fix out of synch Layer 3 table entries.
CLI network-admin@switch > l3-check-fix