port-xcvr-show
This command is used to display information about a transceiver installed in a port on the switch.
Syntax port-xcvr-show
|
port port-list |
Displays the port list. |
|
vendor-name vendor-name-string |
Displays the vendor name for the transceiver. |
|
part-number part-number-string |
Displays the part number of the transceiver. |
|
serial-number serial-number-string |
Displays the serial number. |
|
supported Yes|Warning! Not supported |
Displays information about supported transceivers. |
|
temperature[C] temperature[C]-number |
Displays the port temperature in degrees Centigrade. |
|
vout[mV] vout[mV]-number |
Displays the voltage in millivolts. |
|
tx-bias1[mA] tx-bias1[mA]-string |
Displays the transmit bias current (mA). |
|
tx-pwr[dBm] tx-pwr[dBm]-string |
Displays the transmit power (dBm). |
|
rx-pwr[dBm] rx-pwr[dBm]-string |
Displays receive power (dBm). |
Defaults None.
Access CLI
History
|
Version 1.2.1 |
Command introduced. |
|
Version 2.6.0 |
Transmit and receiver parameters added for lanes. |
Usage Used to display information about SFPs installed in ports on the switch.
Examples
CLI network-admin@switch > port-xcvr-show
switch: aquila-ext-43
port: 8
vendor-name: PluribusNetworks
part-number: QSFP40-CU0P5M
serial-number: V05B6082
supported: Yes
temp[C]: 0.00
vcc[V]: 0.00
tx-bias1[mA]: 0.00
tx-bias2[mA]: 0.00
tx-bias3[mA]: 0.00
tx-bias4[mA]: 0.00
rx-pwr1[dBm]: -Inf
rx-pwr2[dBm]: -Inf
rx-pwr3[dBm]: -Inf
rx-pwr4[dBm]: -Inf