vrouter-vtysh-cmd
Display FRR show output using the Netvisor CLI.
Syntax vrouter-vtysh-cmd name name-string cmd cmd-string
|
name name-string |
Specify the name of the vRouter service configuration. |
|
cmd cmd-string |
Specify any FRR show/debug/undebug/no debug/clear ip/clear ipv6 command. |
Defaults None
Access CLI
History Command introduced in Version 2.5.3.
Usage Use this command to display information on FRR show or debug output.
Examples To display information about IP routing, use the following syntax:
CLI (network-admin@Spine1) > vrouter-vtysh-cmd name vr1 cmd "show ip route"
Codes: K - kernel route, C - connected, S - static, R - RIP,
O - OSPF, I - IS-IS, B - BGP, P - PIM, A - Babel,
> - selected route, * - FIB route
C>* 100.1.1.0/24 is directly connected, eth1.100
C>* 127.0.0.0/8 is directly connected, lo0