igmp-snooping-modify
This command enables or disables Internet Group Management Protocol (IGMP) snooping on the network.
Informational Note: Netvisor does not support IGMPv1. If you use IGMPv1, you must disable IGMP snooping on the Pluribus Networks switch
Syntax igmp-snooping-modify
|
Specify one or more of the following options: |
|
|
scope local|fabric |
Specify if the scope is local or fabric. |
|
enable|disable |
Specify if IGMP snooping is enabled or disabled. |
|
vxlan|no-vxlan |
Specify to enable or disable IGMP snooping on VXLANs. |
|
enable-vlans vlan-list |
Specify a list of VLANs to enable for IGMP. |
|
snoop-linklocal-vlans vlan-list |
Specify if you allow snooping of link-local groups(224.0.0.0/24) on these VLANs. |
|
no-snoop-linklocal-vlans vlan-list
|
Specify if you do not allow snooping of link-local groups(224.0.0.0/24) on these VLANs. |
|
igmpv3-vlans vlan-list |
Specify IGMP Version 3 VLAN list for sending queries. |
|
igmpv2-vlans vlan-list |
Specify IGMP Version 2 VLAN list for sending queries. |
|
query-interval seconds |
Specify the interval between queries in seconds. |
|
query-max-response-time seconds |
Specify the maximum response time for a query. |
Defaults None
Access CLI
History
|
Version 1.2 |
Command introduced. |
|
Version 2.1 |
The parameter, scope, added. |
|
Version 2.4 |
The parameter, version, added. |
|
Version 2.4.1 |
The parameter, version, changed to igmpv2-vlans and igmpv3-vlans. The parameter, enable-vlans, added. |
|
Version 3.1.0 |
The parameters, query-interval and query-max-response-time, added. |
|
Version 5.1.1 |
The parameters vxlan and snoop-linklocal added. |
Usage IGMP snooping allows the switch to listen in on IGMP traffic between hosts and routers, thus maintaining a map of the links that need IP multicast streams. Use this command to modify IGMP snooping on the switch.
Examples To enable IGMP snooping, use the following command:
CLI (network-admin@switch) > igmp-snooping-modify enable