port-fec-mode-show
Use this command to display FEC or specify a user requested FEC mode.
Syntax port-fec-mode-show
|
port port-list |
The port number or list of ports. |
|
mode sys-default|none|base-r|rsfec|rs544|rs544-2xn |
Specify the port FEC mode: sys-default: depends on the configured speed. See default values in the table below. none: fec mode is disabled base-r: fec is using base-r fec rsfec: fec is using rsfec rs544: fec is using rs544 fec rs544-2xn: fec is using rs544-2xn Note: The FEC modes vary for different port speeds. |
Defaults None
Access CLI
History
|
Version 7.0.1 |
Command introduced. |
Usage Use this command to display FEC/ user requested FEC mode.
Information This command is applicable only on Z9432F-ON platform in Netvisor ONE version 7.0.1.
Examples To display the FEC/ user requested FEC mode, use the following command:
CLI (network-admin@switch) > port-fec-mode-show port 5
switch port mode
------ ----- -----------
switch 1-130 sys-default