system-settings-show
This command allows you to display system settings that optimize Netvisor performance.
Syntax system-settings-show
Defaults All parameters enabled by default.
Access Network Administrator
History
|
Version 2.5.2 |
Command introduced |
Usage Use this command to display system settings. However, it is recommended that you do not modify the settings without consulting Pluribus Networks.
Examples To display system settings, use the following syntax:
CLI (network-admin@switch) > system-settings-show
optimize-arps: off
lldp: on
policy-based-routing: off
optimize-nd: off
reactivate-mac: on
reactivate-vxlan-tunnel-mac: on
manage-unknown-unicast: off
manage-broadcast: off
block-loops: off
auto-trunk: on
auto-host-bundle: off
cluster-active-active-routing: on
fast-route-download: off
fast-interface-lookup: on
routing-over-vlags: off
source-mac-miss: copy-to-cpu
igmp-snoop: use-l3
vle-tracking-timeout: 3
pfc-buffer-limit: 40%
cosq-weight-auto: off
port-cos-drop-stats-interval(s): disable
lossless-mode: off
snoop-query-stagger: no-stagger-queries
host-refresh: off
proxy-conn-retry: on
proxy-conn-max-retry: 3
proxy-conn-retry-interval: 500
manage-l2-uuc-drop: on
optimize-rxlos: off
fastpath-bfd: off
linkscan-interval: 150000
linkscan-mode: software
single-pass-l2-known-multicast: off
single-pass-flood: off
single-pass-riot: off
xcvr-oir-debug-port: none
cos-8-and-9-queue: off
batch-move-mac-hw-group-for-vlan-only: off