vrouter-interface-ip-show

This command is used to migrate a vRouter interface from a single stack (IPv4) to dual stack (IPv4, and IPv6) back to a single stack (IPv4).

Syntax   vrouter-interface-ip-remove

vrouter-name name-string

Name of the vRouter.

nic nic-string

The virtual NIC assigned to the interface.

ip ip-address

The IP address assigned to the interface.

netmask netmask

The netmask of the IP address.

Specify any of the following options

vnet vnet-name

The vNET assigned to the vRouter.

l2-net l2-net name

The Layer 2 interface.

type primary|secondary

The IP address as primary or secondary.

Defaults   None

Access   Network administrator

History   

Version 3.0.0

Command introduced.

Version 3.0.4

The parameter type added.

Usage   Use this command to display a vRouter interface with dual stack (IPv4, and IPv6) IP addresses.

Examples  To display an interface with dual stack (IPv4, and IPv6) IP addresses, use the following syntax:

CLI (network-admin@switch) > vrouter-interface-ip-show

vrouter-name nic     vnet vlan vlan-type ip                             assignment nic-state

------------ ------- ---- ---- --------- -----------------------------  ---------- ---------

vr1          eth0.10 0:0  10   public    10.2.3.4/24                    static     up

vr1          eth0.10 0:0  10   public    1000::4/92                     static     up

vr1          eth0.10 0:0  10   public    fe80::640e:94ff:fe17:4f99/64   static     up

north
    keyboard_arrow_up
    keyboard_arrow_down
    description
    print
    feedback
    support
    business
    rss_feed
    south