igmp-static-source-show
This command displays a static IGMP source on the network.
Informational Note: IGMPv1 is not supported in nvOS. If you are using IGMPv1, you must disable IGMP snooping on the Pluribus Networks switch.
Syntax igmp-static-source-show
|
group-ip ip-address |
Specifies the group IP address for IGMP. |
|
vnet vnet-name |
Specify the vNET name assigned to the IGMP static source. |
|
source-ip ip-address |
Specifies the source IP address. |
|
bd bridge-domain name |
Specifies the bridge domain name. |
|
vlan vlan-id |
Specifies the VLAN identifier. |
|
ports port-list |
Specifies the list of ports. |
Defaults None
Access CLI
History
|
Version 1.2 |
Command introduced. |
|
Version 2.4.1 |
The parameter vnet added. |
|
Version 5.1.1 |
The parameter host deprecated, and the parameter bd added. |
Usage IGMP groups are used to determine the reception state for a specific multicast address. This allows the switch to determine if any switches need messages sent from a multicast group. Use this command to remove an IGMP static source.
Examples To display information about all IGMP static source IP addresses, use the following command:
CLI (network-admin@switch) > igmp-static-source-show
switch group-ip vnet bd vlan source-ip ports
------- --------- ---- -- ---- ------------ -----
switch1 224.1.1.1 100 10.16.100.10 123