ip-pool-show
This command displays information about an IP address pool with a specific IP address range.
Syntax ip-pool-show
|
name ip-pool-name |
Specifies the name of the IP pool. |
|
vnet vnet-name |
Specifies the vNET name for the IP pool. |
|
scope local|fabric |
Specifies the scope of the vNET. |
|
start-ip ip-address |
Specifies the first IP address in the pool. This address is included in the pool. |
|
end-ip ip-address |
Specifies the end IP address of the pool, and is included in the pool. |
|
network ip-address |
Specify an IP address group such as 192.168.11.0. |
|
netmask netmask |
Specifies the subnet for the IP address pool. |
|
l2-net l2-net-name |
Specify the name of the Layer 2 network. |
|
vlan vlan-id |
Specifies the VLAN identifier for an IP address pool that applies to a specific Layer 2 network segment. |
|
bd bridge-domain name |
Specify the Bridge Domain assigned to IP pool. |
Defaults None
Access CLI
History
|
Version 1.2 |
Command introduced. |
|
Version 2.2 |
The parameter vnet deprecated. |
|
Version 3.0.0 |
The parameter l2-net added. |
|
Version 5.1.1 |
The parameter l2-net deprecated, and the parameter bd added. |
Usage IP address pools help automate the management of IP addresses for hosts, and virtual machines, including the management IP addresses of the switches in a fabric.
Examples To display information about a fabric-wide IP address pool named vPool, use the following command:
CLI (network-admin@switch) > ip-pool-show name vPool
Name Owner Scope Range Start Range End Nemask Gateway DNS
----- ----- ----- ------------- --------------- ------ --------- ---
vPool None local 192.168.240.1 192.168.240.254 24 10.9.40.1 0