port-autoneg-mode-show
Associate a FEC mode with ports. Use this command to display the autoneg mode.
Syntax port-fec-mode-show
|
port port-list |
The port number or list of ports. |
|
mode sys-default|none|cl73|cl73-msa |
The port autoneg mode. sys-default: depends on the configured speed. See default values below. none: auto negotiation mode is disabled cl73: using clause 73 cl73-msa: use clause 73 multi-source agreement Note: The FEC modes vary for different port speeds. See table below. |
Defaults None
Access CLI
History
|
Version 7.0.1 |
Command introduced. |
Usage Use this command to display the autoneg mode.
Information This command is applicable only on Z9432F-ON platform in NetVisor version 7.0.1.
Examples To display the autoneg mode for port 81, use the following command:
CLI (network-admin@switch) > port-autoneg-mode-show port 81
switch port mode
------ ----- -----------
switch 1-130 sys-default