VLAG Commands
vlag-create
To create a new virtual link aggregation group (VLAG), use this command.
Informational Note: Before you configure VLAGs, you must have two switches in a cluster configuration. One switch is the local switch used to specify the local port, and the other is a peer switch used to specify the peer port.
A switch can only participate in one cluster.
Syntax vlag-create
|
name name-string |
Specify the name of the VLAG. |
|
port vlag-usable-port |
Specify the local VLAG port. |
|
peer-port vlag-usable-port |
Specify the VLAG peer-port. |
|
mode active-standby| |
Specify the mode for the VLAG. Active-standby indicates one side is active, and the other is in standby mode. (Not Supported) Active-Active indicates that both sides of the VLAG are up by default. |
|
peer-switch fabric-node-name |
Specify the fabric name of the peer switch. |
|
failover-move-L2| |
Specify the failover action as move or ignore. |
|
lacp-mode off|passive|active |
Specify the LACP mode. |
|
lacp-timeout slow|fast |
Specify the LACP timeout as slow (30 seconds) or fast (4 seconds). |
|
lacp-fallback bundle|individual |
Specify the LACP fallback mode as bundle or individual. |
|
lacp-fallback-timeout seconds |
Specify the LACP fallback timeout between 30, and 60 seconds. The default value is 50 seconds. |
|
lacp-port-priority number |
Specify the LACP port priority as a value between 1, and 65535. |
Defaults None.
Access CLI
History
|
Version 1.2 |
Command introduced. |
|
Version 2.1 |
The parameters for failover and LACP added. |
|
Version 2.2 |
The parameters for mode lacp-mode, active-standby and active-active added. Local-port changed to port. |
|
Version 2.2.6 |
The parameter port deprecated. The parameters port vlag-usable-port name, and peer-port vlag-usable-port name added. |
|
Version 2.4.0 |
The parameters lacp-fallback and lacp-fallback-timeout added. |
|
Version 2.5.0 |
The parameter lacp-port-priority added. |
Usage A virtual link aggregation group (VLAG) allows links that are physically connected to two different Pluribus Networks devices to appear as a single trunk to a third device. The third device can be a switch, server, or any Ethernet device. A VLAG can provide Layer 2 multipathing, which allows you to create redundancy by increasing bandwidth, enabling multiple parallel paths between nodes, and loadbalancing traffic where alternative paths exist. This command creates a new VLAG.
Examples This example shows how to create a VLAG with identifier 1 to aggregate the links connected to port 1 of both the local, and peer switch.
CLI (network-admin@switch) > vlag-create id 1 port 1 peer-switch a1634:b peer-port 1