vrouter-vtysh-cmd
Display FRR show output using the NetVisor CLI.
Syntax vrouter-vtysh-cmd
|
name name-string |
Specify the name of the vRouter service configuration. |
|
cmd cmd-string |
Specify any FRR show/debug/undebug/no debug/clear ip/clear ipv6 command. |
Defaults None
Access CLI
History
|
Version 2.5.3 |
Command introduced. |
Usage Use this command to display information on FRR show or debug output.
Examples To display information about IP routing, use the following syntax:
CLI (network-admin@Spine1) > vrouter-vtysh-cmd name vr1 cmd "show ip route"
Codes: K - kernel route, C - connected, S - static, R - RIP,
O - OSPF, I - IS-IS, B - BGP, P - PIM, A - Babel,
> - selected route, * - FIB route
C>* 100.1.1.0/24 is directly connected, eth1.100
C>* 127.0.0.0/8 is directly connected, lo0