vtep-show
Previous versions of NetVisor required configuring a tunnel from every node in the fabric, and manually adding VNIs to them. Also, when a new VTEP is added to the fabric, there is no notification about this event, and requires manually creating tunnels from the new node to all other nodes in the fabric. VTEP commands are used to automatically create tunnels between nodes in a fabric.
Syntax vtep-show
|
scope fabric |
The VTEP scope. |
|
name name-string |
Display a name for the VTEP. |
|
location fabric-node-name|host-external |
The location of the switch. |
|
vrouter-name name-string |
The name of the vRouter service. |
|
ip ip-address |
The primary IP address. |
|
virtual-ip ip-address |
The virtual IP address. |
|
description description-string |
The VTEP description. |
|
mac-learning|no-mac-learning |
Display VTEPs with either mac-learning or no-mac-learning configured. |
|
evpn-border true|false |
Display if VTEP is on EVPN border or not. |
Defaults None
Access Network Administrator
History
|
Version 2.6.0 |
Command introduced. |
|
Version 6.0.0 |
The parameter mac-learning added. The keyword host-external for the location parameter added. |
|
Version 6.1.0 |
The parameter evpn-border true|false added. |
Usage Use this command to display a VTEP on a switch.
Examples To display the VTEPs on switch1, use the following syntax:
CLI (network-admin@switch1) > vtep-show format all
scope name location vrouter-name ip virtual-ip description evpn-border
------ ----------- ------------- ------------------- ---------- ---------- ----------- -----------
fabric VTEP1 switch1 vr1 190.11.1.2 190.11.1.1 false
fabric VTEP2 switch2 vr2 190.11.1.3 190.11.1.1 false
fabric VTEP3 switch3 vr3 190.12.1.3 190.12.1.1 false
fabric VTEP4 switch4 vr4 190.12.1.2 190.12.1.1 false
fabric FAB2-VTEP1 host-external 20.1.1.1 false