Create Tunnels using L3 EBGP/OSPF & L3 Third-party EBGP/OSPF on Non-Clustered Leafs

There are features and functions used in Arista NetVisor UNUM and Insight Analytics that are common throughout the user interface (UI). Please refer to the Common Functions section for more information on the use of these functions and features.

Usage Note: Refer to the Fabric Add Switches with Netvisor Fabric License section for more information on executing Playbooks.

After executing the initial Fabric, launch the L3 Playbook to configure eBGP or OSPF configuration.

In the following example, Leaf3 and Leaf4 are non-clustered.

Non-Clustered Leafs Example

The VRRP CSV file input for non-clustered leafs are:


For clustered leaves:


The following is an example of a sample VRRP CSV file for a Fabric with both clustered and non-clustered leaves:




In the image above image, Leaf1 and Leaf2 are the clustered leaf pair. Leaf3 and Leaf4 are the non-clustered leaves in the fabric.

Note: If non-clustered leafs are connected, disable the ports between these switches; otherwise, the module will create a cluster between them, and later the module execution will fail.

Select either Manual Input or Upload CSV (CSV file must contain the requisite values).

Non-Clustered Leafs Manual or CSV Selection

Manual Input

Enter the values manually. The first three columns: VLAN ID, VRRP IP, and Switch Name are required entries. For non-clustered leafs only enter values in these columns.

Click Save to continue.

Non-Clustered Leafs Manual Data Input

Playbook Execution

When the Playbook configuration parameters are correctly entered click Add + and the Playbook execution begins.

NetVisor UNUM Platform Global - Playbook Running

Various messages may appear during the Playbook execution and icons animations will appear on the dashboard indicating progress with the Playbook configuration.


Once the Playbook scenario has been successfully deployed you will see the following message:

NetVisor UNUM Platform Global - Playbook Successfully Deployed

Click Close to complete the configuration.